The TN226 is designed to offer players the ability to travel light without compromising on the features they need to get great tone. The Terra Nova series delivers optimal tone delivery while keeping its amplifiers and enclosures as compact as possible.
The TN226 is great for rehearsal and small bars as well as having a great Di out for when you need to use the front of house system. With a semi parametric mid section and Eden's proprietary enhance EQ sweep getting great sounds from your amplifier is a simple exercise.
Plug your active or high output bass in here.
Plug your passive or low output bass here.
Press this switch to mute and un-mute the amplifier. When the amplifier is muted the light will illuminate.
Use this switch to turn the built in compressor circuit off and on. This LED will illuminate when the compressor feature is switched on.
Adjust the low frequencies of the amplifier using this
control.
Change the amount of frequency adjustment by the low mid freq sweep using this dial.
Adjust the frequency affected by the upper mid freq sweep using this control.
Controls the overall volume of your amplifier.
Adjust the frequency affected by the Low
Mid control from 30 Hz up to 300 Hz using this control.
Adjust the frequency affected by the Hi Mid control from 200 Hz up to 2000 Hz using this control.
Adjust the highest frequencies on the amplifier using this
control.
When illuminated this LED indicates the EQ stage of
the amplifier is casing the amp to clip. To avoid clipping adjust the frequency controls until the light remains off.
Illuminates when unit is switched on.
Use this control to adjust the amount of signal sent into
the preamp stage. Use in conjunction with the Input Gain clip light to avoid clipping the input stage of the amplifier.
This EQ sweep allows quick and effective adjustment of your EQ with a single dial. For best results use the Enhance control with all other EQ settings at 12 O’clock before detailing your tone.
Use this switch to turn on the Bass boost feature on the amplifier. When engaged the Bass control will provide more pronounced Bass adjustment.
Plug your supplied power cord into your Eden amplifier using this mains inlet socket.
Turn the amplifier off and on using this switch.
Connect your unit to a speaker cabinet via a 1/4” Jack cable to this socket.
Connect your unit to a speaker cabinet via a Speakon cable to this socket.
Connect an external device, such as an MP3 player, here using a 3.5mm jack cable.
Connect your headphones here using standard 3.5mm headphone cable.
Connect your foot controller here.
Take your signal to/from your external effect loop or outboard equipment here.
Choose to take the DI signal from either before or after the preamp shaping circuit inside the amplifier.
Connect to either a mixing desk, front of house system or recording device using a standard XLR cable.
Lift ground from your signal (when required) using this switch.
DI Pad: Pad the signal (reduce the output level) between line level and mic level using this switch.
Take your tuner signal out from this socket.
Power Handling: | 225W @ 4Ω |
---|---|
Amp Modes: | Mono |
Freq. Response: | TBC |
Speaker Connection: | Speakon or 1/4" Jack |
Dimensions: | H: 3.1 in / 7.9 cm W: 12.75 in / 32.4 cm D: 6.9 in / 17.5 cm |
Weight: | 4.7 lbs / 2.15 kgs |